Step-by-step directions for gluing inner corners

After finishing, the major problem can be irregular walls as well as the consequent folds on the background. It’s also essential to take into consideration that if the walls are twisted the joints of wallpaper canvases could invisibly.

After gluing the last one in front of the interior corner of the fabric should measure the remaining distance. It is measured from the edge of the pasted cloth to the adjoining wall, and the resulting figure is inserted 10-15 millimeters. When the walls are extremely curved, then the extra figure may be more.

Cut a strip equal to the resultant figure, taking into consideration the allowance. The surfaces have been treated with glue. Based on the type of coating it can be only the wall or surfaces.

The strip is then glued individually with the cut side into the wall. The background should go on the other plane.

In case the glued background is sterile, then you want to make a few little cuts perpendicular to the folds.

Level or incline on the adjoining wall is a perpendicular lineup. The distance in the corner is equivalent to the diameter of the former cut strip, never adding developments.

The surfaces have been smeared with adhesive, and the coat is glued into the wall using the flat side towards the line. The cut gidpola.ru goes on the adjacent wall.

How to glue the outer corner (outer corner)?

Protruding corner should be glued by analogy using an interior, but there are little gaps, which also have to be taken into account when working.

Measured the distance remaining in the glued background into the adjoining wall. Add 20-25 millimeters to the obtained figure.

A section is cut away, taking into account the added 20-25 millimeters.

Prior to gluing, the surfaces are treated with adhesive.

The even edge must be glued into the background fixed onto the walls, the own cut facet”extends” to the adjoining plane. If needed, small cuts are created in the area of visiting another background, smoothed and pressed into the wall.

Draw a vertical strip on the adjacent wall in a distance of just glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is then placed on the wall with its flat side to the line, going over the edge of the already glued strip.

The joints are smeared with glue and ironed using a rollercoaster. Following that, the top layer is trimmed along the ruler and the two layers are joined together.